Enterasys D2 D2G124-12P

Configuring IGMP at Layer 2
11-2 IGMP Configuration
multicastswitch/routeritpassesthroughtoensurethattraffic isonlypassedtothehoststhat
subscribedtothisservice.
Configuring IGMP at Layer 2
Purpose
ToconfigureIGMPsnoopingfromtheswitchCLI.
Commands
show igmpsnooping
UsethiscommandtodisplayIGMPsnoopinginformation.
Syntax
show igmpsnooping
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show igmpsnooping 11-2
set igmpsnooping adminmode 11-3
set igmpsnooping interfacemode 11-4
set igmpsnooping groupmembershipinterval 11-4
set igmpsnooping maxresponse 11-5
set igmpsnooping mcrtrexpiretime 11-5
set igmpsnooping add-static 11-6
set igmpsnooping remove-static 11-7
show igmpsnooping static 11-7
show igmpsnooping mfdb 11-8
clear igmpsnooping 11-8