D-Series CLI Reference 2-1
2
Basic Configuration
Atstartup,theD‐Seriesswitchisconfiguredwithmanydefaultsandstandardfeatures.This
chapterdescribeshowtocustomizebasicsystemsettingstoadapttoyourworkenvironment.
Quick Start Setup Commands
ThetablesinthissectionprovideaquickreferencefortheCLIcommandsneededtobeginbasic
D2switchoperation.Table 2‐3liststasksandtheirassociatedCLIcommandsrequiredforsetting
uptheswitchwiththelatestfirmware.Table 2‐4listsoptionalCLIcommandsthatwillhelpyou
performadditional
basicconfigurationontheswitch.Refertothepageslistedformore
informationabouteachcommand.
For information about... Refer to page...
Quick Start Setup Commands 2-1
Setting User Accounts and Passwords 2-2
Setting Basic Switch Properties 2-8
Activating Licensed Features 2-27
Configuring System Power and Power over Ethernet (PoE) 2-30
Downloading a Firmware Image 2-33
Reviewing and Selecting a Boot Firmware Image 2-36
Starting and Configuring Telnet 2-37
Managing Switch Configuration and Files 2-39
Clearing and Closing the CLI 2-49
Resetting the Switch 2-50
Using and Configuring WebView 2-51
Table 2-3 Required CLI Setup Commands
Step Task CLI commands
Refer to
page...
1 Set a new password. set password [username] 2-5
2 Set the switch IP address. set ip address ip-address [mask
ip-mask] [gateway ip-gateway]
2-9
3 Download, activate, and verify new
firmware on the switch using TFTP
copy.
copy tftp://tftp_server_ip_address/
filename system:image
2-45
set boot system filename 2-37
show version 2-22
To Next Page
Loading...
Need help?
General
