Enterasys D2 D2G124-12P

show spantree bridgeprioritymode
6-10 Spanning Tree Configuration
Defaults
BydefaultBPDUforwardingisdisabled.
Mode
Switchcommand,read‐write.
Usage
TheSpanningTreeprotocolmustbedisabled(setspantreedisable)forthisfeaturetotakeeffect.
Example
ThisexampleshowshowtoenableBPDUforwarding:
D2(rw)-> set spantree bpdu-forwarding enable
show spantree bridgeprioritymode
UsethiscommandtodisplaytheSpanningTreebridgeprioritymodesetting.
Syntax
show spantree bridgeprioritymode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheSpanningTreebridgeprioritymodesetting:
D2(rw)->show spantree bridgeprioritymode
Bridge Priority Mode is set to IEEE802.1t mode.
set spantree bridgeprioritymode
UsethiscommandtosettheSpanningTreebridgeprioritymodeto802.1D(legacy)or802.1t.
Syntax
set spantree bridgeprioritymode {8021d | 8021t}
Parameters
8021d Setsthebridgeprioritymodetouse802.1D(legacy)values,whichare0‐
65535.