Enterasys D2 D2G124-12P

set port advertise
4-16 Port Configuration
Parameters
Defaults
Ifport‐stringisnotspecified,advertisementforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayadvertisementstatusforGigabitports13and14:
D2(su)->show port advertise ge.1.13-14
ge.1.13 capability advertised remote
-------------------------------------------------
10BASE-T yes yes yes
10BASE-TFD yes yes yes
100BASE-TX yes yes yes
100BASE-TXFD yes yes yes
1000BASE-T no no no
1000BASE-TFD yes yes yes
pause yes yes no
ge.1.14 capability advertised remote
-------------------------------------------------
10BASE-T yes yes yes
10BASE-TFD yes yes yes
100BASE-TX yes yes yes
100BASE-TXFD yes yes yes
1000BASE-T no no no
1000BASE-TFD yes yes yes
pause yes yes no
set port advertise
Usethiscommandtoconfigurewhataportwilladvertiseforspeed/duplexcapabilitiesinauto‐
negotiation.
Syntax
set port advertise {port-string}{10t | 10tfd | 100tx | 100txfd | 1000t | 1000tfd
| pause}
Parameters
port‐string (Optional)Displaysadvertisedabilityforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“Port
StringSyntaxUsedintheCLI”onpage4‐1.
port‐string Selecttheportsforwhichtoconfigureadvertisements.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage4‐1.
10t Advertise10BASE‐Thalfduplexmode.
10tfd Advertise10BASE‐Tfullduplexmode.
100tx Advertise100BASE‐TXhalfduplexmode.