Enterasys D2 D2G124-12P - Set Lacp Aadminkey; Clear Lacp

set lacp aadminkey
D-Series CLI Reference 4-39
Mode
Switchcommand,read‐write.
Usage
LACPusesthisvaluetodetermineaggregationprecedence.Iftherearetwopartnerdevices
competingforthesameaggregator,LACPcomparestheLAGIDsforeachgroupingofports.The
LAGwiththelowerLAGIDisgivenprecedenceandwillbeallowedtousetheaggregator.
Example
ThisexampleshowshowtosettheLACPsystempriorityto1000:
D2(su)->set lacp asyspri 1000
set lacp aadminkey
Usethiscommandtosettheadministrativelyassignedkeyforoneormoreaggregatorports.
Syntax
set lacp aadminkey port-string value
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
LACPwillusethisvaluetoformanoperkey.Onlyunderlyingphysicalportswithoperkeys
matchingthoseoftheiraggregatorswillbeallowedtoaggregate.Thedefaultadminkeyvaluefor
allLAGportsis32768.
Example
ThisexampleshowshowtosettheLACPadminkeyto2000forLAGport6:
D2(su)->set lacp aadminkey lag.0.6 2000
clear lacp
UsethiscommandtoclearLACPsystempriorityoradminkeysettings.
Syntax
clear lacp {[asyspri] [aadminkey port-string]}
port‐string SpecifiestheLAGport(s)onwhichtoassignanadminkey.
value Specifiesanadminkeyvaluetoset.Validvaluesare0to65535.The
defaultadminkeyvalueis327 68.