Enterasys D2 D2G124-12P

clear spantree bridgeprioritymode
D-Series CLI Reference 6-11
Defaults
None
Mode
Switchcommand,read‐write.
Usage
Themodeaffectstherangeofpriorityvaluesusedtodeterminewhichdeviceisselectedasthe
SpanningTreerootasdescribedinsetspantreepriority(“setspantreepriority”onpage 6‐17).The
defaultfortheswitchistouse802.1tbridgeprioritymode.
Example
Thisexampleshowshowtosetthebridgeprioritymodeto802.1D:
D2(rw)->set spantree bridgeprioritymode 8021d
clear spantree bridgeprioritymode
UsethiscommandtoresettheSpanningTreebridgeprioritymodetothedefaultsettingof802.1t.
Syntax
clear spantree bridgeprioritymode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetthebridgeprioritymodeto802.1t:
D2(rw)->clear spantree bridgeprioritymode
8021t Setsthebridgeprioritymodetouse802.1tvalues,whichare0to614 40,in
incrementsof4096.Valueswillautomatically beroundedupordown,
dependingonthe802.1tvaluetowhichtheenteredvalueisclosest.
Thisisthedefaultbridgeprioritymode.