Enterasys D2 D2G124-12P

set boot system
D-Series CLI Reference 2-37
Example
Thisexampleshowshowtodisplaytheswitch’sbootfirmwareimage:
D2(su)->show boot system
Current system image to boot: bootfile
set boot system
Usethiscommandtosetthefirmwareimagetheswitchloadsatstartup.
Syntax
set boot system filename
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosetthebootfirmwareimagefileto“newimage”:
D2(su)->set boot system newimage
Starting and Configuring Telnet
Purpose
ToenableordisableTelnet,andtostartaTelnetsessiontoaremotehost.TheD‐Seriesswitch
allowsatotaloffourinboundand/oroutboundTelnetsessiontorunsimultaneously.
Commands
Thecommandsusedtoenable,startandconfigureTelnetarelistedbelow.
filename Specifiesthenameofthefirmwareimagefile.
For information about... Refer to page...
show telnet 2-38
set telnet 2-38
telnet 2-39