Enterasys D2 D2G124-12P - Clear Snmp User

clear snmp user
5-10 SNMP Configuration
Defaults
Ifremoteisnotspecified,theuserwillberegisteredforthelocalSNMPengine.
Ifauthenticationisnotspecified,noauthenticationwillbeapplied.
Ifprivacyisnotspecified,noencryptionwillbeapplied.
Ifstoragetypeisnotspecified,nonvolatilewillbeapplied.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateanewSNMPusernamed“netops”.Bydefault,thisuserwillbe 
registeredonthelocalSNMPenginewithoutauthentication
andencryption.Entriesrelatedtothis
userwillbestoredinpermanent(nonvolatile)memory:
D2(su)->set snmp user netops
clear snmp user
UsethiscommandtoremoveauserfromtheSNMPv3security‐modellist.
Syntax
clear snmp user user [remote remote]
Parameters
Defaults
Ifremoteisnotspecified,theuserwillberemovedfromthelocalSNMPengine.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoremovetheSNMPusernamed“bill”:
D2(su)->clear snmp user bill
volatile|
nonvolatile
(Optional)Specifiesastoragetypeforthisuserentry.
user SpecifiesanSNMPv3usertoremove.
remoteremote (Optional)RemovestheuserfromaspecificremoteSNMPengine.