Enterasys D2 D2G124-12P - Clear Config; Using and Configuring Webview; Purpose

clear config
D-Series CLI Reference 2-51
Examples
Thisexampleshowshowtoresetthesy stem:
D2(su)->reset
This command will reset all modules and may disconnect your telnet session.
Do you want to continue (y/n) [n]?
clear config
Usethiscommandtocleartheuser‐definedconfigurationparameters.
Syntax
clear config
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ExecutingthiscommandwillcleartheconfigurationinbothNVRAMandonthememorycard,if
oneisinstalledontheswitch.
ThiscommandwillnotcleartheIPaddressoftheswitch.Usetheclearipaddresscommandto
cleartheIPaddress.
Example
Thisexampleshowshowtoclearconfigurationparameters:
D2(su)->clear config
Using and Configuring WebView
Purpose
Bydefault,WebView(TheEnterasysNetworksembeddedwebserverforswitchconfiguration
andmanagementtasks)isenabledonTCPportnumber80ontheD‐Seriesswitch.Youcanverify
WebViewstatus,andenableordisableWebViewusingthecommandsdescribedinthissection.
WebViewcanalsobesecurelyusedover
SSLport443,ifSSLisenabledontheswitch.Bydefault,
SSLisdisabled.
TouseWebView,typetheIPaddressoftheswitchinyourbrowser.TouseWebViewoverSSL,
typeinhttps://thentheIPaddressoftheswitch.Forexample,https://172.16.2.10.