Enterasys D2 D2G124-12P

Clearing and Closing the CLI
D-Series CLI Reference 2-49
Example
Thisexampleshowshowtocleartheretryvaluetothedefaultof5retries.
D2(rw)-> clear tftp retry
Clearing and Closing the CLI
Purpose
TocleartheCLIscreenortocloseyourCLIsession.
Commands
ThecommandsusedtoclearandclosetheCLIsessionarelistedbelow.
cls (clear screen)
UsethiscommandtoclearthescreenforthecurrentCLIsession.
Syntax
cls
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtocleartheCLIscreen:
D2(su)->cls
exit
UseeitherofthesecommandstoleaveaCLIsession.
Syntax
exit
For information about... Refer to page...
cls 2-49
exit 2-49