To Next Page

To Previous Page

set dhcp pool hardware-address

14-14 DHCP Server Configuration

Defaults

None.

Mode

Switchcommand,read‐write.

Example

Thisexampledeletesthenetworkandmaskfromtheaddresspoolnamed“auto1.”

D2(rw)->clear dhcp pool auto1 network

set dhcp pool hardware-address

UsethiscommandtoconfiguretheMACaddressoftheDHCPclientandcreateanaddresspool

formanualbinding.Youcanuseeitherthiscommandorthesetdhcppoolclient‐identifier

commandtocreateamanualbindingpool,butusingbothisnotrecommended.

Syntax

set dhcp pool poolname hardware-address hw-addr [type]

Parameters

Defaults

Ifnotypeisspecified,Ethernetisassumed.

Mode

Switchcommand,read‐write.

Example

Thisexamplespecifies0001.f401.2710astheEthernetMACaddressforthemanualaddresspool

named“manual1.”Alternatively,theMACaddresscouldhavebeenteredas00:01:f4:01:27:10.

D2(rw)->set dhcp pool manual1 hardware-address 0001.f401.2710

clear dhcp pool hardware-address

UsethiscommandtoremovethehardwareaddressofaDHCPclientfromamanualbinding

addresspool.

Syntax

clear dhcp pool poolname hardware-address

poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31

charactersinlength.

hw‐addr SpecifiestheMACaddressoftheclient’shardwareplatform.Thisvalue

canbeenteredusingdottedhexadecimalnotationorcolons.

type (Optional)Specifiestheprotocolofthehardwareplatform.Validvalues

are1

forEthernetor6forIEEE802.Defaultvalueis1,Ethernet.

Enterasys D2 D2G124-12P User Manual

Questions and Answers: