Enterasys D2 D2G124-12P

Configuring General DHCP Server Parameters
D-Series CLI Reference 14-3
Configuring General DHCP Server Parameters
Purpose
ToconfigureDHCPserverparameters,andtodisplayandclearaddressbindinginformation,
serverstatistics,andconflictinformation.
Commands
set dhcp
UsethiscommandtoenableordisabletheDHCPserverfunctionalityontheD‐Series.
Syntax
set dhcp {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
set dhcp 14-3
set dhcp bootp 14-4
set dhcp conflict logging 14-4
show dhcp conflict 14-5
clear dhcp conflict 14-5
set dhcp exclude 14-6
clear dhcp exclude 14-6
set dhcp ping 14-7
clear dhcp ping 14-7
show dhcp binding 14-8
clear dhcp binding 14-8
show dhcp server statistics 14-9
clear dhcp server statistics 14-10
enable|disable EnablesordisablesDHCPserverfunctionality.Bydefault,DHCPserver
isdisabled.