Enterasys D2 D2G124-12P

set port enable
4-8 Port Configuration
set port enable
Usethiscommandtoadministrativelyenableoneormoreports.
Syntax
set port enable port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoenablege.1.3:
D2(su)->set port enable ge.1.3
show port alias
Usethiscommandtodisplaythealiasnameforoneormoreports.
Syntax
show port alias [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,aliasesforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayaliasinformationforports1‐3onslot3:
D2(rw)->show port alias ge.3.1-3
Port ge.3.1 user
Port ge.3.2 user
Port ge.3.3 Admin
port‐string Specifiestheport(s)toenable.Foradetaileddescriptionofpossibleport‐
stringvalues,referto“PortStringSyntax UsedintheCLI”onpage4‐1.
port‐string (Optional)Displaysaliasname(s)forspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage4‐1.