Enterasys D2 D2G124-12P

set multiauth idle-timeout
15-38 Security Configuration
set multiauth idle-timeout
Usethiscommandtosetthemaximumnumberofconsecutivesecondsanauthenticatedsession
maybeidlebeforeterminationofthesession.
Syntax
set multiauth idle-timeout [dot1x | mac | pwa] timeout
Parameters
Defaults
Ifnoauthenticationmethodisspecified,theidletimeoutvalueissetforallauthentication
methods.
Mode
Switchmode,read‐write.
Usage
Ifyousetanidletimeoutvalue,aMACuserwhoseMACaddresshasagedoutoftheforwarding
databasewillbeunauthenticatedifnotraffichasbeenseenfromthataddressforthespecifiedidle
timeoutperiod.
Avalueofzeroindicatesthatnoidletimeoutwillbeappliedunless
anidletimeoutvalueis
providedbytheauthenticatingserver.Forexample,ifasessionisauthenticatedbyaRADIUS
server,thatservermayencodeaIdle‐TimeoutAttributeinitsauthenticationresponse.
Example
Thisexamplesetstheidletimeoutvalueforallauthenticationmethodsto300seconds.
D2(su)->set multiauth idle-timeout 300
clear multiauth idle-timeout
Usethiscommandtoresetthemaximumnumberofconsecutivesecondsanauthenticatedsession
maybeidlebeforeterminationofthesessiontoitsdefaultvalueof0.
Syntax
clear multiauth idle-timeout [dot1x | mac | pwa]
dot1x (Op tional)SpecifiestheIEEE802.1Xport‐basednetworkaccesscontrol
authenticationmethodforwhichtosetthetimeoutvalue.
mac (Optional)SpecifiestheEnterasysMACauthenticationmethodfor 
whichtosetthetimeoutvalue.
pwa (Optional)SpecifiestheEnterasysPortWebAuthenticationmethodfor
whichtosetthetimeoutvalue.
timeout Specifies
thetimeoutvalueinseconds.Thevaluecanrangefrom0to
65535.Avalueof0meansthatnoidletimeoutwillbeappliedunlessan
idletimeoutvalueisprovidedbytheauthenticatingserver.