Enterasys D2 D2G124-12P - Set Snmp Notify; Show Snmp Notify Output Details

set snmp notify
D-Series CLI Reference 5-31
Defaults
Ifanotifynameisnotspecified,allentrieswillbedisplayed.
Ifvolatile,nonvolatile,orread‐onlyarenotspecified,allstoragetypeentrieswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheSNMPnotifyinformation:
D2(su)->show snmp notify
--- SNMP notifyTable information ---
Notify name = 1
Notify Tag = Console
Notify Type = trap
Storage type = nonVolatile
Row status = active
Notify name = 2
Notify Tag = TrapSink
Notify Type = trap
Storage type = nonVolatile
Row status = active
Table 5‐26providesanexplanationofthecommandoutput.
set snmp notify
UsethiscommandtosettheSNMPnotifyconfiguration.ThiscreatesanentryintheSNMPnotify
table,whichisusedtoselectmanagementtargetswhoshouldreceivenotificationmessages.This
command’stagparametercanbeusedtobindeachentrytoatargetaddressusingthesetsnmp
targetaddrcommand
(“setsnmptargetaddr”onpage 5‐26).
Syntax
set snmp notify notify tag tag [trap | inform] [volatile | nonvolatile]
Parameters
Table 5-26 show snmp notify Output Details
Output Field What It Displays...
Notify name A unique identifier used to index the SNMP notify table.
Notify Tag Name of the entry in the SNMP notify table.
Notify Type Type of notification: SNMPv1 or v2 trap or SNMPv3 InformRequest
message.
Storage type Whether access entry is stored in volatile, nonvolatile, or read-only
memory.
Row status Status of this entry: active, notInService, or notReady.
notify SpecifiesanSNMPnotifyname.