Enterasys D2 D2G124-12P

set multiauth session-timeout
15-40 Security Configuration
set multiauth session-timeout
Usethiscommandtosetthemaximumnumberofsecondsanauthenticatedsessionmaylast
beforeterminationofthesession.
Syntax
set multiauth session-timeout [dot1x | mac | pwa] timeout
Parameters
Defaults
Ifnoauthenticationmethodisspecified,thesessiontimeoutvalueissetforallauthenticati on
methods.
Mode
Switchmode,read‐write.
Usage
Avalueofzeromaybesupersededbyasessiontimeoutvalueprovidedbytheauthenticating
server.Forexample,ifasessionisauthenticatedbyaRADIUSserver,thatservermayencodea
Session‐TimeoutAttributeinitsauthentication response.
Example
Thisexamplesetsthesession timeoutvaluefortheIEEE802.1Xauthenticationmethodto300
seconds.
D2(su)->set multiauth session-timeout dot1x 300
clear multiauth session-timeout
Usethiscommandtoresetthemaximumnumberofconsecutivesecondsanauthenticatedsession
maylastbeforeterminationofthesessiontoitsdefaultvalueof0.
Syntax
clear multiauth session-timeout [dot1x | mac | pwa]
dot1x (Op tional)SpecifiestheIEEE802.1Xport‐basednetworkaccesscontrol
authenticationmethodforwhichtosetthesessiontimeoutvalue.
mac (Optional)SpecifiestheEnterasysMACauthenticationmethodfor 
whichtosetthesessiontimeoutvalue.
pwa (Optional)SpecifiestheEnterasysPortWebAuthenticationmethodfor
whichtosetthesessiontimeout
value.
timeout Specifiesthetimeoutvalueinseconds.Thevaluecanrangefrom0to
65535.Avalueof0meansthatnosessiontimeoutwillbeappliedunless
asessiontimeoutvalueisprovidedbytheauthenticatingserver.