Enterasys D2 D2G124-12P

show logging application
12-6 Logging and Network Management
Defaults
Atleastoneoptionalparametermustbeentered.
Allthreeoptionalkeywordsmustbeenteredtoresetallloggingvaluestodefaults.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresettheSyslogdefaultseveritylevelto6:
D2(su)->clear logging default severity
show logging application
UsethiscommandtodisplaytheseveritylevelofSyslogmessagesforoneorallapplications 
configuredforloggingonyoursystem.
Syntax
show logging application [mnemonic | all]
Parameters
Defaults
Ifnoparameterisspecified,informationforallapplicationswillbedisplayed.
Mode
Switchcommand,read‐only.
port (Optional)ResetsthedefaultUDPporttheclientusestosendtotheserver
to514.
mnemonic (Optional)Displaysseveritylevelforoneapplicationconfiguredfor
logging.Mnemonicswillvarydependingonthenumberandtypesof
applicationsrunningonyoursystem.Samplemnemonicsandtheir
correspondingapplicationsarelistedinTable 12‐38onpage 12‐8.
Note: Mnemonic values are case sensitive and must be typed as they appear in
Table 12-38.
all (Optional)Displaysseveritylevelforallapplicationsconfiguredfor
logging.