Enterasys D2 D2G124-12P

set cdp hold-time
D-Series CLI Reference 3-5
set cdp hold-time
UsethiscommandtosettheholdtimevalueforCDPdiscoveryprotocolconfigurationmessages.
Syntax
set cdp hold-time hold-time
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtosetCDPholdtimeto60seconds:
D2(su)->set cdp hold-time 60
clear cdp
UsethiscommandtoresetCDPdiscoveryprotocolsettingstodefaults.
Syntax
clear cdp {[state] [port-state port-string] [interval] [hold-time] [auth-code]}
Parameters
Defaults
Atleastoneoptionalparametermustbeentered.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresettheCDPstatetoauto‐enabled:
D2(su)->clear cdp state
hold‐time SpecifiestheholdtimevalueforCDPmessagesinseconds.Validvaluesare
from15to600.
state (Optional)ResetstheglobalCDPstatetoauto ‐enabled.
port‐stateport‐string (Optional)Resetstheportstateonspecificport(s)toauto‐enabled.
interval (Optional)Resetsthemessagefrequencyintervalto60seconds.
hold‐time (Optional)Resetstheholdtimevalueto180seconds.
auth‐code (Optional)Resetstheauthenticationcodeto16
bytesof00(00‐00‐00‐
00‐00‐00‐00‐00).