Enterasys D2 D2G124-12P

Globally Enabling or Disabling Diffserv
8-2 Differentiated Services Configuration
Globally Enabling or Disabling Diffserv
Purpose
TogloballyenableordisableDiffservonthedevice.
Command
ThecommandusedtogloballyenableordisableDiffservonthedeviceislistedbelowand
describedintheassociatedsectionasshown.
set diffserv adminmode
UsethiscommandtogloballyenableordisableDiffservonthedevice.Bydefault,thisfunctionis
disabledatdevicestartup.
Syntax
set diffserv adminmode {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoenableDiffserv:
D2(rw)->set diffserv adminmode enable
For information about... Refer to page...
set diffserv adminmode
8‐2
enable|disable EnablesordisablesDiffserv.