Enterasys D2 D2G124-12P

show port txq
D-Series CLI Reference 10-7
show port txq
UsethiscommandtodisplayQoStransmitqueueinformationforoneormorephysicalports.
Syntax
show port txq [port-string]
Parameters
Defaults
Iftheport‐stringisnotspecified,the QoSsettingofallphysicalportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshows howtodisplaythecurrentalgorithmandtransmitqueueweightsconfigured
onport
ge.1.10:
D2(su)->show port txq ge.1.10
Port Alg Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7
----- --- --- --- --- --- --- --- --- ---
ge.1.10 WRR 10 10 15 20 25 20 0 0
set port txq
UsethiscommandtosetQoStransmitqueuearbitrationvaluesforphysicalports.
Syntax
set port txq port-string value0 value1 value2 value3 value4 value5 value6 value7
set port txq 10-7
clear port txq 10-8
For information about... Refer to page...
port‐string (Optional)Specifiesport(s)forwhichtodisplayQoSsettings.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.
Onlyphysicalportswillbedisplayed.LAGportshavenotransmitqueue
information.