Enterasys D2 D2G124-12P - Set Length; Show Logout

set length
D-Series CLI Reference 2-25
Example
Thisexampleshowshowtosettheterminalcolumnsto50:
D2(su)->set width 50
set length
UsethiscommandtosetthenumberoflinestheCLIwilldisplay.This commandispersistent
(writtentoNV‐RAM).
Syntax
set length screenlength
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosettheterminallengthto50:
D2(su)->set length 50
show logout
Usethiscommandtodisplaythetime(inseconds)anidleconsoleorTelnetCLIsessionwill
remainconnectedbeforetimingout.
Syntax
show logout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
screenlength SetsthenumberoflinesintheCLIdisplay.Validvaluesare0,which
disablesthescrollingscreenfeaturedescribedin“DisplayingScrolling
Screens”onpage1‐8,andfrom5to512.