Enterasys D2 D2G124-12P

Configuring Multiple Authentication Methods
15-30 Security Configuration
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleresetstheMACauthenticationsignificantbitsto48.
D2(su)->clear macauthentication significant-bits
Configuring Multiple Authentication Methods
About Multiple Authentication Types
Whenenabled,multipleauthenticationtypesallowuserstoauthenticateusingmorethanone
methodonthesameport.Inorderformultipleauthenticationtofunctiononthedevice,each
possiblemethodofauthentication(MACauthentica tion, 802.1X,PWA)must beenabledglobally
andconfiguredappropriatelyonthedesiredportswithitscorresponding
commandsetdescribed
inthischapter.
Multipleauthenti cationmodemustbegloballyenabledonthedeviceusingthesetmultiauth
modecommand.
Commands
Note: D2 devices support up to eight authenticated users per port.
For information about... Refer to page...
show multiauth 15-31
set multiauth mode 15-31
clear multiauth mode 15-32
set multiauth precedence 15-33
clear multiauth precedence 15-33
show multiauth port 15-34
set multiauth port 15-34
clear multiauth port 15-35
show multiauth station 15-36
show multiauth session 15-36
show multiauth idle-timeout 15-37