Enterasys D2 D2G124-12P

clear lacp singleportlag
4-42 Port Configuration
previousLAGmemberportscomesupconnectedtothesameswitchasbeforetheLAGwent
down.
Example
ThisexampleenablestheformationofsingleportLAGs:
D2(su)->set lacp singleportlag enable
clear lacp singleportlag
UsethiscommandtoresetthesingleportLAGfunctionbacktothedefaultstateofdisabled.
Syntax
clear lacp singleportlag
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoresetthesingleportLAGfunctionbacktodisabled:
D2(su)->clear lacp singleportlag
show port lacp
Usethiscommandtodisplaylinkaggregationinformationforoneormoreunderlyingphysical
ports.
Syntax
show port lacp port port-string {[status {detail | summary}] | [counters]}
Parameters
Defaults
None.
portport‐string DisplaysLACPinformationforspecificport(s).Foradetaileddescription
ofpossibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage4‐1.
statusdetail|
summary
DisplaysLACPstatusindetailedorsummaryinformation.
counters DisplaysLACPcounterinformation.