Enterasys D2 D2G124-12P - Show Maclock; Show Maclock Output Details

show maclock
D-Series CLI Reference 15-47
show maclock
UsethiscommandtodisplaythestatusofMAClockingononeormoreports.
Syntax
show maclock [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,MAClockingstatuswillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayMAClockinginformationforge.1.1.
D2(su)->show maclock ge.1.1
MAC locking is globally enabled
Port Port Trap Aging Max Static Max FirstArrival Last Violating
Number Status Status Status Allocated Allocated MAC Address
------- ------- -------- ------- ---------- --------------- ---------------
ge.1.1 enabled disabled enabled 20 1 00:a0:c9:39:5c:b4
Table 15‐51providesanexplanationofthecommandoutput.
set maclock static 15-52
clear maclock static 15-52
set maclock firstarrival 15-53
clear maclock firstarrival 15-54
set maclock agefirstarrival 15-54
clear maclock agefirstarrival 15-55
set maclock move 15-55
set maclock trap 15-56
For information about... Refer to page...
port‐string (Optional)DisplaysMAClockingstatusforspecifiedport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.
Table 15-51 show maclock Output Details
Output Field What It Displays...
Port Number Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 4-1.