To Next Page

To Previous Page

show cos port-resource

9-26 Policy Classification Configuration

Example

Thisexamplesetstheinboundratelimitresourceindexnumber1forportgroup2.0to10000Kbps

or1MB:

D2(su)->set cos port-resource irl 2.0 1 unit kbps rate 10000 type drop

show cos port-resource

UsethiscommandtodisplaytheIRLportresources.

Syntax

show cos port-resource [irl [group-type-index [irl-index]]]

Parameters

Defaults

IfaportgroupandIRLindexarenotspecified,theIRLconfigurationforallresources(0‐99)forall

configuredportgroupswillbeshown.

Mode

Switchcommand,read‐only.

Example

ThisexampledisplaystheIRLresourceindexnumber1configurationforgroup2.0.

D2(su)->show cos port-resource irl 2.0 1

'?' after the rate value indicates an invalid rate value

Group Index Resource Type Unit Rate Rate Limit Type Action

----------- -------- ---- ---- ---------- --------------- ------

2.0 1 irl kbps 10000 drop none

clear cos port-resource

UsethiscommandtosettheinboundratelimitinKbps.

Syntax

clear cos port-resource irl {all | group-type-index [irl-index [unit] [rate]

[type]]}

irl (Optional)Specifiesthatinboundratelimitingportresourcesshouldbe

displayed.

group‐type‐index (Optional)Specifiesaninboundratelimitingportgroup/typeindex.Valid

entriesareintheformofgroup#.port‐type.

Validvaluesforgroup#canrangefrom0to7.Validvaluesforport‐type

canrangefrom0

to1,althoughonlyporttype0iscurrentlysupported.

Forexample,portgroup3wouldbespecifiedas3.0.

irl‐index (Optional)Inboundratelimiterresourceindexconfiguredforthe

specifiedportgroup.Validvaluesrangefrom0to99.

Enterasys D2 D2G124-12P User Manual

Questions and Answers: