Enterasys D2 D2G124-12P

show multiauth idle-timeout
D-Series CLI Reference 15-37
Defaults
Ifnooptionsarespecified,multipleauthenticationsessionentrieswillbedisplayedforall
sessions,authenticationtypes,MACaddresses,andports.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaymultipleau thenticationsessioninformationforportge.1.1.
D2(su)->show multiauth session port ge.1.1
__________________________________________
Port | ge.1.1 Station address | 00-01-03-86-0A-87
Auth status | success Last attempt | FRI MAY 18 11:16:36 2007
Agent type | dot1x Session applied | true
Server type | radius VLAN-Tunnel-Attr | none
Policy index | 0 Policy name | Administrator
Session timeout | 0 Session duration | 0,00:00:25
Idle timeout | 5 Idle time | 0,00:00:00
Termination time | Not Terminated
show multiauth idle-timeout
Usethiscommandtodisplaythetimeoutvalue,inseconds,foranidlesessionforall
authenticationmethods.
Syntax
show multiauth idle-timeout
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytimeoutvaluesfor anidlesessionforallauthenticationtypes.
D2(su)->show multiauth idle-timeout
Authentication type Timeout (sec)
------------------- -------------
dot1x 0
pwa 0
mac 0