set logging server
D-Series CLI Reference 12-3
set logging server
UsethiscommandtoconfigureaSyslogserver.
Syntax
set logging server index [ ip-addr ip-addr] [facility facility] [severity severity]
[descr descr] [port port] [state {enable | disable}]
Parameters
Defaults
Ifip‐addrisnotspecified,anentryintheSyslogservertablewillbecreatedwiththespecified
indexnumberandamessagewilldisplayindicatingthatnoIPaddresshasbeenassigned.
Ifnotspecified,facility, severityandportwillbesettodefaultsconfiguredwiththesetlogging
defaultcommand(“setloggingdefault”onpage 12‐5).
Ifstateisnotspecified,theserverwillnotbeenabledordisabled.
Mode
Switchcommand,read‐write.
Example
ThiscommandshowshowtoenableaSyslogserverconfigurationforindex1,IPaddress
134.141.89.113,facilitylocal4,severitylevel3onport514:
D2(su)->set logging server 1 ip-addr 134.141.89.113 facility local4 severity 3
port 514 state enable
index Specifiestheservertableindexnumberforthisserver.Validvaluesare1‐
8.
ip‐addrip‐addr (Optional)SpecifiestheSyslogmessageserver’sIPaddress.
facilityfacility (Optional)Specifiestheserver’sfacilityname.Validvaluesare:local0to
local7.
severityseverity (Optional)Specifiestheseveritylevelatwhichtheserverwill
log
messages.Validvaluesandcorrespondinglevelsare:
1—emergencies(systemisunusable)
2—alerts(immediateactionrequired)
3—criticalconditions
4—errorconditions
5—warningconditions
6—notifications(significantconditions)
7—informationalmessages
8—debuggingmessages
descrdescr (Optional)Specifiesatextualstringdescriptionofthisfacility/server.
portport (Optional)SpecifiesthedefaultUDPporttheclientusestosendtothe
server.
stateenable|
disable
(Optional)Enablesordisablesthisfacility/serverconfiguration.
To Next Page
Loading...
Need help?
General
