Enterasys D2 D2G124-12P User Manual

D-Series CLI Reference 4-1
4
Port Configuration
ThischapterdescribesthePortConfigurationsetofcommandsandhowtousethem.
Port Configuration Summary
Port String Syntax Used in the CLI
Commandsrequiringaport‐stringparameterusethefollowingsyntaxtodesignateporttype,slot
location,andportnumber:
porttype.unitnumber.portnumber
Whereporttypecanbe:
gefor1‐GbpsEthernet
hostforthehostport
vlanforvlaninterfaces
lagforIEEE802.3linkaggregationports
Whereunitnumberis1
fortheD2standaloneunit,and
Portnumbercanbe:
1–12fortheD2G124‐12andtheD2G124‐12P
Thehighestvalidportnumberisdependentonthenumberofportsinthedeviceandtheport
type.
For information about... Refer to page...
Port Configuration Summary 4-1
Reviewing Port Status 4-3
Disabling / Enabling and Naming Ports 4-7
Setting Speed and Duplex Mode 4-9
Enabling / Disabling Jumbo Frame Support 4-12
Setting Auto-Negotiation and Advertised Ability 4-14
Setting Flow Control 4-18
Setting Port Link Traps and Link Flap Detection 4-19
Configuring Broadcast Suppression 4-28
Port Mirroring 4-31
Link Aggregation Control Protocol (LACP) 4-33
Configuring Protected Ports 4-47

Enterasys D2 D2G124-12P Specifications

General

Brand	Enterasys
Model	D2 D2G124-12P
Category	Network Router
Language	English