Enterasys D2 D2G124-12P - Set Console Baud; Activating Licensed Features

set console baud
D-Series CLI Reference 2-27
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayallconsolesettings:
D2(su)->show console
Baud Flow Bits StopBits Parity
------ ------- ---- ---------- ------
9600 Disable 8 1 none
set console baud
Usethiscommandtosettheconsoleportbaudrate.
Syntax
set console baud rate
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtosettheconsoleportbaudrateto19200:
D2(su)->set console baud 19200
Activating Licensed Features
InordertoenabletheD2advancedfeatures,suchasPolicy ,youmustpurchaseandactivatea
licensekey.Ifyouhavepurchasedalicense,youcanproceedtoactivateyourlicenseasdescribed
inthissection.Ifyouwishtoobtainapermanentorevaluationlicense,usetheEnterasys
Customer
PortalorcontacttheEnterasysNetworksSalesDepartment.
rate Setstheconsolebaudrate.Validvaluesare:300,600,1200,2400,4800,5760,
9600,14400,19200,38400,and115200.