Enterasys D2 D2G124-12P

set tftp retry
2-48 Basic Configuration
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearthetimeoutvaluetothedefaultof2seconds.
D2(rw)-> clear tftp timeout
set tftp retry
UsethiscommandtoconfigurehowmanytimesTFTPwillresendapacket,eitheran
acknowledgementpacketoradatapacket.
Syntax
set tftp retry retry
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplesetstheretrycountto3.
D2(rw)->set tftp retry 3
clear tftp retry
UsethiscommandtoresettheTFTPretryvaluetothedefaultvalueof5retries.
Syntax
clear tftp retry
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
retry Specifiesthenumberoftimesapacketwillberesent.Thevalidrangeis
from1to1000.Defaultvalueis5retries.