Enterasys D2 D2G124-12P - Configuring SNMP MIB Views; Commands; Purpose; Show Snmp View

Configuring SNMP MIB Views
D-Series CLI Reference 5-19
Configuring SNMP MIB Views
Purpose
ToreviewandconfigureSNMPMIBviews.SNMPviewsmapSNMPobjectstoaccessrights.
Commands
show snmp view
UsethiscommandtodisplaytheMIBconfigurationforSNMPv3view‐basedaccess(VACM).
Syntax
show snmp view [viewname] [subtree oid-or-mibobject] [volatile | nonvolatile |
read-only]
Parameters
Defaults
Ifnoparametersarespecified,allSNMPMIBviewconfigurationinforma tionwillbedisplayed.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show snmp view 5-19
show snmp context 5-20
set snmp view 5-21
clear snmp view 5-22
viewname (Optional)DisplaysinformationforaspecificMIBview.
subtreeoid‐or‐mibobject (Optional)DisplaysinformationforaspecificMIBsubtreewhen
viewnameisspecified.
volatile|nonvolatile|
read‐only
(Optional)Displaysentriesforaspecificstoragetype.