To Next Page

To Previous Page

set newaddrtrap

5-30 SNMP Configuration

set newaddrtrap

UsethiscommandtoenableordisableSNMPtrapmessaging,globallyorononeormoreports,

whennewsourceMACaddressesaredetected.

Syntax

set newaddrtrap [port-string] {enable | disable}

Parameters

Defaults

Ifport‐stringisnotspecified,thetrapfunctionissetglobally.

Mode

Switchmode,read‐write.

Usage

ThiscommandenablesanddisablessendingSNMPtrapmessageswhenanewsourceMAC

addressisdetectedbyaport.IftheportisaCDPport,however,trapsfornewsourceMAC

addresseswillnotbesent.

Thedefaultmodeisdisabledgloballyandperport.

Example=

ThisexampleenablesthetrapfunctiongloballyandthenonGigabitEthernetports1through5in

slot1.

D2(rw)->set newaddrtrap enable

D2(rw)->set newaddrtrap ge.1.1-5 enable

show snmp notify

UsethiscommandtodisplaytheSNMPnotifyconfiguration,whichdeterminesthemanagement

targetsthatwillreceiveSNMPnotifications.

Syntax

show snmp notify [notify] [volatile | nonvolatile | read-only]

Parameters

port‐string (Optional)EnableordisablethenewMAC addressestrapfunctionon

specificports.

enable|disable EnableordisablethenewMACaddressestrapfunction.Ifentered

withouttheport‐stringparameter,enablesordisablesthefunction

globally.Whenenteredwiththeport‐stringparameter,enablesor

disablesthefunction

onspecificports.

notify (Optional)Displaysnotifyentriesforaspecificnotifyname.

volatile|

nonvolatile|read‐

only

(Optional)Displaysnotifyentriesforaspecificstoragetype.

Enterasys D2 D2G124-12P User Manual

Questions and Answers: