set port negotiation
D-Series CLI Reference 4-15
Parameters
Defaults
Ifport‐stringisnotspecified,auto‐negotiationstatusforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayauto‐negotiationstatusfor1‐GigabitEthernetport14inslot 3:
D2(su)->show port negotiation ge.3.14
auto-negotiation is enabled on port ge.3.14.
set port negotiation
Usethiscommandtoenableordisableauto‐negotiationononeormoreports.
Syntax
set port negotiation port-string {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtodisableauto‐negotiationon1‐GigabitEthernetport3inslot14:
D2(su)->set port negotiation ge.3.14 disable
show port advertise
Usethiscommandtodisplayportcapabilityandadvertisementasfarasspeedandduplexfor
auto‐negotiation.
Syntax
show port advertise [port-string]
port‐string (Optional)Displaysauto‐negotiationstatusforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage4‐1.
port‐string Specifiestheport(s)forwhichtoenableordisableauto‐negotiation.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage4‐1.
enable|disable Enablesordisablesauto‐negotiation.
To Next Page
Loading...
Need help?
General
