Enterasys D2 D2G124-12P

clear dhcp server statistics
14-10 DHCP Server Configuration
clear dhcp server statistics
UsethiscommandtoclearallDHCPservercounters.
Syntax
clear dhcp server statistics
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleclearsallDHCPservercounters.
D2(rw)->clear dhcp server statistics
Configuring IP Address Pools
Manual Pool Configuration Considerations
•ThesubnetoftheIPaddressbeingissuedshouldbeonthesamesubnetastheingress
interface(thatis,thesubnetofthehostIPaddressoftheswitch,orifroutinginterfacesare
configured,thesubnetoftheroutinginterface).
•Amanualpoolcanbeconfiguredusingeitherthe
client’shardwareaddress(setdhcppool
hardware‐address)ortheclient’sclient‐identifier(setdhcppoolclient‐identifier),butusing
bothisnotrecommended.
•IftheincomingDHCPrequestpacketcontainsaclient‐identifier,thenamanualpool
configuredwiththatclient‐identifiermustexistontheswitchin
orderfortherequesttobe
processed.Thehardwa readdressisnotchecked.
•Ahardwareaddressandtype(EthernetorIEEE802)configuredinamanualpoolischecked
onlywhenaclient‐identifierisnotalsoconfiguredforthepoolandtheincomingDHCP
requestpacketdoesnotincludea
client‐identifieroption.
Purpose
ToconfigureandclearDHCPaddresspoolparameters,andtodisplayaddresspoolconfiguration
information.
Note: A total of 16 address pools, dynamic and/or static, can be configured on the D-Series.