Enterasys D2 D2G124-12P

clear spantree legacypathcost
D-Series CLI Reference 6-31
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Bydefault,legacypathcostisdisabled.Enablingthedevicetocalculatelegacypathcostsaffects
therangeofvalidvaluesthatcanbeenteredinthesetspantreeadminpathcostcommand.
Example
Thisexampleshowshowtosetthedefaultpathcostvaluesto802.1D.
D2(rw)->set spantree legacypathcost enable
clear spantree legacypathcost
UsethiscommandtosettheSpanningTreedefaultvaluefor legacypathcostto802.1tvalues.
Syntax
clear spantree legacypathcost
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleclearsthelegacypathcostto802.1tvalues.
D2(rw)->clear spantree legacypathcost
Configuring Spanning Tree Port Parameters
Purpose
TodisplayandsetSpanningTreeportparameters.
Commands
For information about... Refer to page...
set spantree portadmin 6-32
clear spantree portadmin 6-32
show spantree portadmin 6-33