Enterasys D2 D2G124-12P

clear spantree adminedge
6-38 Spanning Tree Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thedefaultbehavioroftheedgeportadministrativestatusbeginswiththevaluesettofalse
initiallyafterthedeviceispoweredup.IfaSpanningTreeBDPUisnotreceivedontheportwithin
afewseconds,thestatussettingchangestotrue.
Example
Thisexampleshowshowtosetge.1.11asanedgeport:
D2(su)->set spantree adminedge ge.1.11 true
clear spantree adminedge
UsethiscommandtoresetaSpanningTreeporttonon‐edgestatus.
Syntax
clear spantree adminedge port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetge.1.11asanon‐edgeport:
D2(su)->clear spantree adminedge ge.1.11
Configuring Spanning Tree Loop Protect Parameters
Purpose
TodisplayandsetSpanningTreeLoopProtectparameters,includingtheglobalparametersof
LoopProtectthreshold,window,enablingtraps,anddisputedBPDUthreshold,aswellasperport
andport/SIDparameters.See“LoopProtect”onpage 6‐2formoreinformationabouttheLoop
Protectfeature.
port‐string Specifiesport(s)on
whichtoresetedgeportstatus.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 4‐1.