Enterasys D2 D2G124-12P

set spantree portadmin
6-32 Spanning Tree Configuration
set spantree portadmin
UsethiscommandtodisableorenabletheSpanningTreealgorithmononeormoreports.
Syntax
set spantree portadmin port-string {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtodisableSpanningTreeonge.1.5:
D2(rw)->set spantree portadmin ge.1.5 disable
clear spantree portadmin
UsethiscommandtoresetthedefaultSpanningTreeadminstatustoenableononeormoreports.
Syntax
clear spantree portadmin port-string
show spantree portpri 6-33
set spantree portpri 6-34
clear spantree portpri 6-35
show spantree adminpathcost 6-35
set spantree adminpathcost 6-36
clear spantree adminpathcost 6-36
show spantree adminedge 6-37
set spantree adminedge 6-37
clear spantree adminedge 6-38
For information about... Refer to page...
port‐string Specifiestheport(s)forwhichtoenableordisableSpanningTree.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.
disable|enable DisablesorenablesSpanningTree.