Enterasys D2 D2G124-12P

show snmp persistmode
2-40 Basic Configuration
Purpose
TosetandviewthepersistencemodeforCLIconfigurationcommands,manuallysavethe
runningconfiguration,view,manage,andexecuteconfigurationfilesandimagefiles,andsetand
viewTFTPparameters.
Commands
show snmp persistmode
Usethiscommandtodisplaytheconfigurationpersistencemodesetting.
Syntax
show snmp persistmode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Usage
Bydefault,themodeissetto“autosave,”whichautomaticallysavesconfigurationchangesat
specificintervals.Ifthemodeissetto“manual,”configurationcommandsareneverautomatically
For information about... Refer to page...
show snmp persistmode 2-40
set snmp persistmode 2-41
save config 2-41
dir 2-42
show file 2-43
show config 2-44
configure 2-45
copy 2-45
delete 2-46
show tftp settings 2-46
set tftp timeout 2-47
clear tftp timeout 2-47
set tftp retry 2-48
clear tftp retry 2-48