Enterasys D2 D2G124-12P - Set Lacp Static

set lacp static
4-40 Port Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocleartheactoradminkeyforLAGport6:
D2(su)->clear lacp aadminkey lag.0.6
set lacp static
Usethiscommandtodisableorenablestaticlinkaggregation,ortoassignoneormoreunderlying
physicalportstoaLinkAggregationGroup(LAG).
Syntax
set lacp static {disable | enable} | lagportstring [key] port-string
Parameters
Defaults
Ifnotspecified,akeywillbeassignedaccordingtothespecifiedaggregator.Forexampleakeyof
4wouldbeassignedtolag.0.4.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoaddportge.1.6totheLAGofaggregatorport6:
D2(su)->set lacp static lag.0.6 ge.1.6
asyspri Clearssystem priority.
aadminkeyport‐string Resetsadminkeysforoneormoreportstothedefaultvalueof32 768.
disable|enable Disablesorenablesstaticlinkaggregation.
lagportstring SpecifiestheLAGaggregatorporttowhichnewportswillbeassigned.
key (Optional)Specif iesthenewmemberportandLAGportaggregator
adminkeyvalue.Onlyportswithmatchingkeysareallowedto
aggregate.Validvaluesare0‐65535.
Note: This key value must be unique. If ports other than the desired
underlying physical ports share the same admin key value, aggregation
will fail or undesired aggregations will form.
port‐string Specifiesthememberport(s)toaddtotheLAG.For adetaileddescription
ofpossibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”
onpage4‐1.