Enterasys D2 D2G124-12P

clear nodealias config
D-Series CLI Reference 12-33
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Uponpacketreception,nodealiasesaredynamicallyassignedtoportsenabledwithanalias
agent,whichisthedefaultsettingonD‐Seriesdevices.Nodealiasescannotbestaticallycreated,
butcanbedeletedusingtheclearnodealiascommandasdescribedin“clearnodealiasconfig”on
page 12‐33.
Example
Thisexampleshowshowtodisablethenodealiasagentonge.1.3:
D2(su)->set nodealias disable ge.1.3
clear nodealias config
Usethiscommandtoresetnodealiasstatetoenabledandclearthemaximumentriesvalue.
Syntax
clear nodealias config port-string
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetthenodealiasconfigurationonge.1.3:
D2(su)->clear nodealias config ge.1.3
enable|disable Enablesordisablesanodealiasagent.
maxentriesmaxentries Setthemaximumnumberofaliasentriesperports.Validrangeis0to
4096.Thedefaultvalueis32.
port‐string Specifiestheport(s)onwhichtoenable/disablenodealiasagentorset
amaximumnumberofentries.
port‐string Specifiestheport(s)onwhichtoresetthenodealiasconfiguration.