Enterasys D2 D2G124-12P

show rmon channel
13-16 RMON Configuration
show rmon channel
UsethiscommandtodisplayRMONchannelentriesforoneormoreports.
Syntax
show rmon channel [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,informationaboutallchannelswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRMONchannelinformationforge.2.12:
D2(rw)->show rmon channel ge.2.12
Port ge.2.12 Channel index= 628 EntryStatus= valid
----------------------------------------------------------
Control off AcceptType matched
OnEventIndex 0 OffEventIndex 0
EventIndex 0 Status ready
Matches 4498
Description Thu Dec 16 12:57:32 EST 2004
Owner NetSight smith
set rmon channel
UsethiscommandtoconfigureanRMONchannelentry.
Syntax
set rmon channel index port-string [ accept { matched | failed}] [control { on | off}]
[description description] [owner owner]
Parameters
port‐string (Optional)DisplaysRMONchannelentriesforaspecificport(s).
index Specifiesanindexnumberforthisentry.Anentrywillautomaticallybe
createdifanunusedindexnumberischosen.Maximumnumberof
entriesis2.Maximumvalueis65535.
port‐string Specifiestheportonwhichtrafficwillbemonitored.
acceptmatched|
failed
(Optional)Specifiestheactionofthe
filtersonthischannelas:
• matched‐Packetswillbeacceptedonfiltermatches
• failed‐Packetswillbeacceptediftheyfailamatch
controlon|off (Optional)Enablesordisablescontroloftheflowofdatathroughthe
channel.