Enterasys D2 D2G124-12P

show system enhancedbuffermode
D-Series CLI Reference 2-15
show system enhancedbuffermode
Usethiscommandtodisplaythestatusofenhancedbuffermode,whichoptimizesbuffer
distributionforsingleCoSqueueoperation.
Syntax
show system enhancedbuffermode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtodisplayenhancedbuffermodestatus:
D2(su)->show system enhancedbuffermode enable
Optimized system buffer distribution Disable
set system enhancedbuffermode
Usethiscommandtoenableordisableenhancedbuffermode,whichoptimizesbuffer
distributionforsingleCoSqueueoperation.Executingthiscommandwillresettheswitch,sothe
systempromptsyoutoconfirmwhetheryouwanttoproceed.
Syntax
set system enhancedbuffermode {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoenableenhancedbuffermode:
D2(su)->set system enhancedbuffermode enable
Changes in the enhanced buffer mode will require resetting this unit.
Are you sure you want to continue? (y/n)
enable|disable Enablesordisablesenhancedbuffermode.