Enterasys D2 D2G124-12P - Show Newaddrtrap

show newaddrtrap
D-Series CLI Reference 5-29
show newaddrtrap
Usethiscommandtodisplaythe globalandport‐specificstatusoftheSNMPnewMACaddresses
trapfunction.
Syntax
show newaddrtrap [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,thestatusofthenewMACaddressestrapfunctionwillbedisplayed
forallports.
Mode
Switchcommand,read‐only.
Usage
Bydefault,thisfunctionisdisabledglobally andperport.
Example
ThisexampledisplaysthestatusforGigabitEthernetports1through5inslot1.
D2(ro)->show newaddrtrap ge.1.1-5
New Address Traps Globally disabled
Port Enable State
--------- ------------
ge.1.1 disabled
ge.1.2 disabled
ge.1.3 disabled
ge.1.4 disabled
ge.1.5 disabled
show snmp notifyfilter 5-33
set snmp notifyfilter 5-33
clear snmp notifyfilter 5-34
show snmp notifyprofile 5-35
set snmp notifyprofile 5-35
clear snmp notifyprofile 5-36
For information about... Refer to page...
port‐string (Optional)DisplaysthestatusofthenewMACaddressestrapfunction
onspecificports.