Enterasys D2 D2G124-12P - Show Spantree Lpcapablepartner

show spantree lpcapablepartner
D-Series CLI Reference 6-43
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
ThedefaultvalueforLoopProtectcapablepartnerisfalse.IftheportisconfiguredwithaLoop
Protectcapablepartner(true),thenthefullfunctionality oftheLoopProtectfea ture isused.Ifthe
valueisfalse,thenthereissomeambi guityastowhetheranActivePartnertimeoutis
duetoa
loopprotectioneventorisanormalsituationduetothefactthatthepartnerportdoesnot
transmitAlternateAgreementBPDUs.Therefore,aconservativeapproachistakeninthat
designatedportswillnotbeallowedtoforwardunlessreceivingagreementsfromaportwithroot
role.
This
typeoftimeoutwillnotbeconsideredaloopprotectionevent. Loopprotectionismaintained
bykeepingtheportfromforwardingbutsincethisisnotconsideredaloopeventitwillnotbe
factoredinto lockingtheport.
Example
ThisexampleshowshowtosettheLoopProtectcapablepartnertotrueforge.1.1:
D2(rw)->set spantree lpcapablepartner ge.1.1 true
show spantree lpcapablepartner
UsethiscommandtotheLoopProtectcapabilityofalinkpartnerforoneormoreports.
Syntax
show spantree lpcapablepartner [port port-string]
Parameters
Defaults
Ifnoport‐stringisspecified,LoopProtectcapabilityforlinkpartnersisdisplayedforallports.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplaytheLoopProtectpartnercapabilityforge.1.1:
D2(rw)->show spantree lpcapablepartner port ge.1.1
Link partner of port ge.1.1 is not LoopProtect-capable
true|false Specifieswhetherthelinkpartneriscapable(true)ornot(false).
port‐string (Optional)Specifiesport(s)forwhichtodisplayLoopProtectcapability
foritslinkpartner.