Enterasys D2 D2G124-12P

Setting User Accounts and Passwords
2-2 Basic Configuration
Setting User Accounts and Passwords
Purpose
Tochangetheswitch’sdefaultuserloginandpasswordsettings,andtoaddnewuseraccounts
andpasswords.
Commands
Thecommandsusedtoconfigureuseraccountsandpasswordsarelistedbelow.
Table 2-4 Optional CLI Setup Commands
Task CLI commands
Refer to
page...
Save the active configuration. save config 2-41
Enable or disable SSH. set ssh enable | disable 15-69
Enable or disable Telnet. set telnet {enable | disable} [inbound |
outbound | all]
2-38
Enable or disable HTTP
management (WebView).
set webview {enable | disable} 2-52
Enable or disable SNMP port link
traps.
set port trap port-string {enable | disable} 4-20
Set the per port broadcast limit set port broadcast port-string threshold-value 4-29
Configure a VLAN. set vlan create vlan-id 7-4
set port vlan port-string vlan-id modify-egress 7-8
Set a Syslog server IP and
severity
set logging server index ip-addr ip-addr
severity severity state enable
7-8
Configure and enable a RADIUS
server.
set radius server index ip-addr
port [secret-value]{realm { management-access |
any | network-access}
15-5
set radius enable 15-5
Configure and enable first arrival
MAC locking on user ports.
set maclock firstarrival port-string value 15-54
set maclock enable port-string 15-49
For information about... Refer to page...
show system login 2-3
set system login 2-4
clear system login 2-4
set password 2-5
set system password length 2-6
set system password aging 2-6
set system password history 2-7
show system lockout 2-7