Enterasys D2 D2G124-12P

set port alias
D-Series CLI Reference 4-9
set port alias
Usethiscommandtoassignanaliasnametoaport.
Syntax
set port alias port-string [name]
Parameters
Defaults
Ifnameisnotspecified,thealiasassignedtotheportwillbecleared.
Mode
Switchcommand,read‐write.
Examples
Thisexampleshowshowtoassignthealias“A d m i n ” toge.3.3:
D2(rw)->set port alias ge.3.3 Admin
Thisexampleshowshowtoclearthealiasforge.3.3:
D2(rw)->set port alias ge.3.3
Setting Speed and Duplex Mode
Purpose
ToreviewandsettheoperationalspeedinMbpsandthe defaultduplexmode:Half,forhalf
duplex,orFull,forfullduplexforoneormoreports.
Commands
port‐string Specifiestheporttowhichanaliaswillbeassigned.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage4‐1.
name (Optional)Assignsanaliasnametotheport.Ifthealiasnamecontains
spaces,thetext
stringmustbesurroundedbydoublequotes.Maximum
lengthis60characters.
Note: These settings only take effect on ports that have auto-negotiation disabled.
For information about... Refer to page...
show port speed 4-10
set port speed 4-10
show port duplex 4-11
set port duplex 4-14