Enterasys D2 D2G124-12P

set linkflap threshold
4-26 Port Configuration
Parameters
Defaults
Ifport‐stringisnotspecified,actionswillbeclearedonallports.
Mode
Switchmode,read‐write.
Example
Thisexampleshowshowtoclearthelinkflapviolationactiononportge.1.4togeneratinga
Syslogentry.
D2(rw)->clear linkflap action ge.1.4 gensyslogentry
set linkflap threshold
Usethiscommandtosetthelinkflapactiontriggercount.
Syntax
set linkflap threshold port-string threshold-value
Parameters
Defaults
None.
Mode
Switchmode,read‐write.
Example
Thisexampleshowshowtosetthelinkflapthresholdonportge.1.4to5.
D2(rw)->set linkflap threshold ge.1.4 5
port‐string (Optional)Specifiestheport(s)onwhichtoclearthelinkflapaction.
disableInterface Clearsthereactionasdisablingtheinterface.
gensyslogentry Clearsthereactionasgeneratingasyslogentry.
gentrap ClearsthereactionasgeneratinganSNMPtrap.
all Clearsthereactionasalloftheabove.
port‐string Specifiestheport(s)onwhichtosetthelinkflapactiontriggercount.
threshold‐value Specifiesthenumberoflinkdowntransitionsnecessarytotriggerthe
linkflapaction.Aminimumof1mustbeconfigured.