Enterasys D2 D2G124-12P - Set Multiauth Mode; Show Multiauth

show multiauth
D-Series CLI Reference 15-31
show multiauth
Usethiscommandtodisplaymultipleauthenticationsystemconfiguration.
Syntax
show multiauth
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaymultipleau thenticationsystemconfiguration:
D2(rw)->show multiauth
Multiple authentication system configuration
-------------------------------------------------
Supported types : dot1x, pwa mac
Maximum number of users : 768
Current number of users : 2
System mode : multi
Default precedence : dot1x, pwa, mac
Admin precedence : dot1x, pwa, mac
Operational precedence : dot1x, pwa, mac
set multiauth mode
Usethiscommandtosetthesystemauthenticationmodetoallowmultipleauthenticators
simultaneously(802.1xPWA,andMACAuthentication)onasingleport,ortostrictlyadhereto
802.1xauthentication.
Syntax
set multiauth mode {multi | strict}
set multiauth idle-timeout 15-38
clear multiauth idle-timeout 15-38
show multiauth session-timeout 15-39
set multiauth session-timeout 15-40
clear multiauth session-timeout 15-40
For information about... Refer to page...