Enterasys D2 D2G124-12P

Configuring Port Web Authentication (PWA)
D-Series CLI Reference 15-57
Configuring Port Web Authentication (PWA)
About PWA
PWAprovidesawayofauthenticatingusersbeforeallowinggeneralaccesstothenetwork
TologonusingPWA,theusermakesarequestthroughawebbrowserforthePWAwebpageor
isautomaticallyredirectedtothisloginpageafte rrequestingaURLinabrowser.
Dependinguponthe
authenticatedstateoftheuser,aloginpageoralogoutpagewilldisplay.
Whenausersubmitsusernameandpassword,theswitchthenauthenticatestheuserviaa
preconfiguredRADIUSserver.Iftheloginissuccessful,thentheuserwillbegrantedfullnetwork
accessaccordingtotheuser’s
policyconfigurationontheswitch.
Purpose
Toreview,enable,disable,andconfigurePortWebAuthentication(PWA).
Commands
PWA PWA
Note: One user per PWA-configured port can be authenticated on D-Series devices.
PWA authentication does not support RFC-3580 VLAN authorization.
For information about... Refer to page...
show pwa 15-58
set pwa 15-58
show pwa banner 15-60
set pwa banner 15-60
clear pwa banner 15-61
set pwa displaylogo 15-61
set pwa ipaddress 15-62
set pwa protocol 15-62
set pwa guestname 15-63
clear pwa guestname 15-63
set pwa guestpassword 15-64
set pwa gueststatus 15-64
set pwa initialize 15-65
set pwa quietperiod 15-65
set pwa maxrequest 15-66
set pwa portcontrol 15-66
show pwa session 15-67
set pwa enhancedmode 15-68