Enterasys D2 D2G124-12P - Set Multiauth Port; Show Multiauth Port

show multiauth port
15-34 Security Configuration
show multiauth port
Usethiscommandtodisplaymultipleauthenticationpropertiesforoneormoreports.
Syntax
show multiauth port [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,multipleauthenticationinformationwillbedisplayedforallports.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaymultipleau thenticationinformationforportsge.3.1‐4:
D2(rw)->show multiauth port ge.3.1-4
Port Mode Max Allowed Current
users users users
------------ ------------ ---------- ---------- ----------
ge.3.1 auth-opt 8 8 0
ge.3.2 auth-opt 8 8 0
ge.3.3 auth-opt 8 8 0
ge.3.4 auth-opt 8 8 0
set multiauth port
Usethiscommandtosetmultipleauthenticationpropertiesforoneormoreports.
Syntax
set multiauth port mode {auth-opt | auth-reqd | force-auth | force-unauth} |
numusers numusers port-string
Parameters
port‐string (Optional)Displaysmultipleauthenti cationinformationforspecificport(s).
mode
auth‐opt|
auth‐reqd|
force‐auth|
force‐unauth
Specifiestheport(s)’multipleauthenticationmodeas:
• auth‐opt—Authenticationoptional(“non‐strict”behavior).Ifauser
doesnotattempttoauthenticateusing802.1x,orif802.1x
authenticationfails,theportwillallowtraffictobeforwarded
according
tothedefined defaultVLAN.
• auth‐reqd—Authentication isrequired.
• force‐auth—Authenticati onconsidered.
• force‐unauth—Authenticationdisabled.
numusers
numusers
Specifiesthenumberofusersallowedauthenticationonport(s).Valid
valuesare0to8.